Search The Knowledge Base

Browse By Category
Error: Thermal label output
Would you like to...
Print this pagePrint this page
Email this pageEmail this page
Post a commentPost a comment
Subscribe me
Add to favoritesAdd to favorites
Remove HighlightingRemove Highlighting
Edit this ArticleEdit this Article
Edit this Article Quick Edit
Export to PDF
User Opinions (43 votes)
62% thumbs up 37% thumbs down
How would you rate this answer?
Helpful
Not helpful

If you receive an error that says it's unable to close the interface and device it's likely due to a mis-matched power adapter on your LP2844 printer. Be sure to use a Hitek Power adapter, Model # PLUS120 with 20V, 2.5A output.

You can purchase new adapters from the Zebra UPS (Power Supply, 100-240V, IEC320C5) website.

See attachment below for a reference photo of this power adapter.
Related Articles
No Related Articles Were Found
Attachments
No Attachments Related to This Article

Continue